Connecting The Instrument - sylvac PS16 V2 Mode D'emploi

6.1. Re-initialising the instrument
The initial instrument settings can be restored at any time by a prolonged press (>4
sec) simultaneously on
now needs to be reinitialised.
6.2. Personalising the instrument
Access to the functions of your instrument can be personalised, for more information
see manufacturer's website (requires you to connect your instrument via an USB
cable, Proximity or Bluetooth
Possibilities :
- Enable or disable the required functions
- Modify access to the advanced functions (direct access)

6.3. Connecting the instrument

The instrument can be connected to a peripheral device via a USB, or Proximity
cable or via Bluetooth
can be controlled with the help of predefined remote commands (for a list of the main
commands, see chap. 7).
Note :
In Tolerance mode, the tolerance limit lights remain lit only for a few seconds while the
measurement stabilises. However, they will remain permanently lit if the instrument is
connected and powered by the USB connector.
and
MODE SET
).
®
. Measurement values can be transmitted and the instrument
®
until the message rESEt. The instrument
15
E