Install The Bumpers; Install The Casters - Gladiator Garageworks GAMGD027LG01 Instructions D'assemblage

Install the Bumpers

WARNING
Excessive Weight Hazard
Use two or more people to move and assemble cabinet
or locker.
Failure to do so can result in back or other injury.
NOTE: The drawers must be pushed in completely to lock.
1. Close and lock the drawers. Remove the key.
2. Remove the top mat from the cabinet.
3. Using two or more people, turn the cabinet upside down.
4. Attach the bumpers to the front corners of the tool chest
using 4 washers and 4 socket-head cap screws for each
bumper.
NOTE: To keep from stripping the screws, do not overtighten.
5. Using the hex-key wrench provided, tighten all the screws.
1. Bumper
2. Washer
3. Socket-head cap screw
4

Install the Casters

1. Insert the carriage-head bolts into the keyhole slots and slide
to the narrow end, seating the bolt in place as shown.
2. Attach the 2 rigid casters (with left-side brakes) to the front
caster plates and start the 4 self-locking nuts for each caster.
3. Hold the casters in place making sure the bolts are seated in
the narrow ends of the keyhole slots. Tighten the self-locking
nuts with a ⁷⁄₁₆ in. wrench.
1
4. Repeat steps 2 and 3 to attach the 2 swivel casters to the
rear caster plates as shown.
2
3
5. Return the cabinet to its upright position.
6. Replace the top mat with the textured side facing up.
7. Unlock the drawers.
8. Place the liners in the drawers.
1. Swivel casters
2. Caster plate
3. Rigid casters
4. Front of cabinet
1
2
3
4