Table des Matières
Publicité
Anleitung_REH_5547_SPK1:_
Releasing any of the switches will bring the hedge
trimmer to a stop.
In so doing, please check the running of the
blades.
b
Please check that the blades function correctly.
The blades cut on both sides and run in opposite
directions to each other, for guaranteed high
cutting performance and quiet operation.
b
Fasten the extension cable to the cable holder
before starting to use the machine (see Fig. 2).
b
For use in the open air you must only use
extension cables certified for the purpose.
Tips on use
b
The hedge trimmer can be used not only for
trimming hedges but for trimming shrubs and
bushes as well.
b
For optimum trimming performance, guide the
blade teeth at an angle of approx. 15° to the
hedge (see Fig. 3).
b
Since the blades cut on both sides and run in
opposite directions to each other, you can trim in
both directions (see Fig. 4).
b
To achieve a hedge with a uniform height it is
recommended that you stretch a piece of string
along the edge of the hedge for guidance. Then
simply cut away all twigs projecting above the
line (see Fig. 5).
b
The sides of the hedge should be trimmed with
arc-type movements from below upwards (see
Fig. 6).
7. Replacing the power cable
If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
8. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
b
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
15.12.2008
9:36 Uhr
Seite 9
b
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
b
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts
of the equipment. Ensure that no water can seep
into the device.
8.2 Maintenance
b
Um stets beste Leistungen zu erhalten, sollten
die Messer regelmäßig gereinigt und geschmiert
werden. Entfernen Sie die Ablagerungen mit
einer Bürste und tragen Sie einen leichten Ölfilm
auf (siehe Bild 7).
b
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
9. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
10. Faults
The machine does not start: Check that the power
cable is correctly connected and check the mains
fuses. If the machine still does not work even with
connected voltage, please send it to the specified
customer services address.
GB
9
Publicité
Table des Matières
