Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
14.4 Heat transfer fluid
The OKSOL system is supplied with the primary circuit filled with the necessary amount of heat
transfer fluid (Solar Coolant -12; Propylene Glycol content 25%).
Appearance
pH at 20ºC
Boiling point in circuit
Protection temperature
Density at 20ºC
Viscosity at 20ºC
Heat capacity at 20ºC
Coefficient of thermal expansion
15. SPARE PARTS
Only original spare parts from ORKLI S.Coop. should be used for repair and maintenance to ensure longlasting
operation of all components of the unit and to keep it in good condition.
It is necessary to ensure that these parts are assembled correctly, in their proper position and facing their
installation direction.
16. DISMANTLING AND RECYCLING
Dismantling the solar system is specially simple. Even so, and in accordance with safety regulations, it must be
carried out by qualified personnel.
OKSOL is largely made up of resistant and recyclable plastic material.
Both the packaging and the system and all its contents must not be thrown away, but must be removed of
according to the regulations in force.
17. LABELING
The OKSOL solar DHW system is identified by a label. All system details are stated on the label. The information
provided on the labels is important for future system identification.
Removing labels will make future identification difficult and may cause service issues.
PRODUCT FEATURES
Liq. Yellow Transparent
8.5 - 9.5
127ºC
-12ºC
1.02 - 1.03 g/ml
2.33 mPa s
3.95 KJ/KgK
0.00046 1/K
EN
41
Publicité
Table des Matières
