Cleaning And Maintenance; Troubleshooting - Dometic CFX3 Série Notice D'utilisation

Cleaning and maintenance

8 Cleaning and maintenance
A
NOTICE! Damage hazard
• Never clean the cooler under running water or in dish water.
• Do not use abrasive cleaning agents or hard objects during cleaning
as these can damage the cooler.
➤ Occasionally clean the device interior and exterior with a damp cloth.
➤ Make sure that the air inlet and outlet vents on the device are free of any dust and
dirt, so that heat can be released and the device is not damaged.
9

Troubleshooting

I
NOTE
Customer service: customersupportcenter@dometic.com or 1-800-544-4881
Fault
The device does not
function (DC mode,
ignition on).
34
Possible cause
No voltage was
detected in the
DC power outlet.
The DC outlet is dirty.
This results in a poor
electrical contact.
The fuse of the DC plug
has blown.
The device DC fuse has
blown.
The vehicle fuse has
blown.
Suggested remedy
In most vehicles the ignition must be
turned on before power will be supplied
to the DC power outlet.
If the plug of the device becomes very
warm in the DC outlet, either the
DC outlet must be cleaned or the plug
has not been assembled correctly.
Replace the fuse in the DC plug, see
chapter "Replacing the DC plug fuse" on
page 33.
Replace the device DC fuse, see chapter
"Replacing the DC fuse" on page 33.
Replace the vehicle's DC outlet fuse.
Please refer to your vehicle's operating
manual.
CFX3
EN