Operation; 5.1 In General; Switching The Voltage Converter On/Off - Goobay 58890 SPW IT 1000 Mode D'emploi

4. Connect the red battery cable (10) with the eyelet to the positive terminal
of the battery.
This is red or marked with „P" or „+".
5. Connect the black battery cable (10) with the eyelet to the negative pole
of the battery.
This is black or marked with „N" or „-".
Voltage converters, which are supplied with 2 red and black battery cables
each, ALL cables must be connected with loads >1000 W.
• Not connecting the ground terminal may cause electric
shock when equipment defects.
6. Connect the ground cable (11) to the ground terminal (4) and to an
available ground system such as the vehicle body or for stationary use,
at equipotential.

5 Operation

5.1 In general

Some external devices such as audio and battery-powered devices and pre-
cision equipment may not be suitable to operate at a voltage converter and
the connected device and/or the voltage converter may get damaged.
1. Check the user manual of the device to be connected to corresponding
notices.
2. Turn the device off immediately and unplug the power cord when it hums
or excessively heates up.
3. If there is anything unclear, contact the dealer of your device.
Both AC outputs 230 V (7) and the DC output USB 5 V (9) can be used si-
multaneously. The total power rating for all connected equipment must not
exceed the continuous output of the voltage converter. The power rating of
your equipment can be found on the nameplate. External devices, such as
electric motors, drills, electric saws, refrigerators and music systems normally
have a higher rated power when starting as indicated on the nameplate. The
voltage converter can therefore briefly make a higher peak output power if the
power rating is only given in current as ampere,
• multiply the value in amperes (A) by a factor of 230 to to obtain the power
in watts (W).
Example: 0.5 A x 230 V = 115 W
The vehicle battery discharges when the vehicle is not in operation.
5.2

Switching the voltage converter on/off

1. Turn the On/Off switch (8) on (ON).
If the Operation LED (5) lights, the voltage converter is ready for operation.
2. Should the Error LED (6) light, turn off the voltage converter by pressing
the On/Off switch (OFF) and read the chapter „Troubleshooting."
Risk of electric shock!
18