Installing The Router - CMT ORANGE TOOLS CMT300 Manuel D'instructions

InSTALLInG THe ROUTeR

3) Installing the router
To use the CMT300 system, a router is required, on which a guide ring must be fitted, to enable the machine
to be controlled on the template.
50mm
Guide ring
(50mm wheelbase)
Router
be impossible to install the guide ring on the router being used (due to the dimensions), a universal sub-base
(supplied separately) is available.
This sub-base has an external diameter of 170mm and is supplied with a line-up/centering pin to enable it
to be correctly fitted to the router.
Optional universal sub-base supplied separately
CMT300-SB1 (for Ø8 and Ø12mm shanks)
CMT300-SB2 (for Ø6.35 and Ø12.7mm shanks)
Universal sub-base
(for guide ring)
Line-up
centering pin
Once the guide is installed on the router, a CMT dovetail bit can be fitted for machining the wood.
4) Using the CMT300 with a standard CMT300-T128 template
The CMT300 system is supplied with a standard template (CMT300-T128), with which 12.7mm half-blind
dovetail joints can be machined using a normal CMT dovetail bit (purchased separately).
Bits that can be used with the standard CMT300-T128 template:
718.127.11 (Ø6mm shank)
818.128.11 (Ø6.35mm shank)
918.127.11 (Ø8mm shank)
21.5mm
9.5mm
Half-blind dovetail joint
(3/8")
(CMT300-T128)
12.7mm
(1/2")
7
www.cmtutensili.com