CMT ORANGE TOOLS CMT300 Manuel D'instructions page 6

ASSeMBLInG THe CMT300
All that has to be done now is to tighten the two screws with the over-sized locking knobs in the threaded
holes.
Repeat this procedure for the front bar.
Fig.4
Fig.5
Fig.6
Adjusting the template
Fig. 5: Lastly, place the template on the body of the CMT300.
To do so, just fit the supports (13) between parts 2 and 11.
Fig. 6: Once the template is positioned, it can be adjusted on the two axes - X and Y. Just tighten or loosen
the stop nut (2) for X-axis settings and raise or lower the guides (13) for Y-axis settings. Once the exact
setting has been found, tighten nut 12 to lock in place. Assembly is now complete.
6
www.cmtutensili.com