Knick A 26000 Mode D'emploi page 15

2. Intended Use
The Series A 26000 universal isolated signal conditioners are used for galvanic
isolation of 0 to ±20 mA and 0 to ±10 V signals. Depending on the model, input
and output signals are permanently set or you can select calibrated ranges by
means of DIP switches.
Fine-adjusting is not required for the models with switch selection.
Signal transmission is linear.
The broad-range power supply allows operating the devices with voltages from
22 to 230 V AC/DC ±10 %.
Type H1 is connected by means of pluggable screw terminals, type F1 by means
of fixed screw terminals.
Warning against misuse
Do not operate the device outside the conditions specified by
the manufacturer, as this might result in hazards to operators or
malfunction of the equipment.
CAUTION
The operating company is responsible for the safety of the installation
in which the device is operated.
3. Configuration (A 26000 F1 and A 26000 H1 only)
3.1 Tools
A screwdriver with a width of 3 mm is required to open the device and to
connect the wires to the screw terminals.
15