Trouble Shooting - Talsa F14s Mode D'emploi

HYDRAULIC PISTON FILLERS F14/25/35/50

9. Trouble shooting

 ALWAYS power off and unplug the
machine from the electrical outlet before
proceeding with cleaning, maintenance, or
repairs.
 If you are unable to resolve the difficulty, DO
NOT CONTINUE TO USE THE MACHINE
and contact your authorized Talsa dealer for
service.
© Talsabell s.a. All rights reserved.
Talsa fillers are manufactured with the highest grade materials and components and subjected to rigorous quality controls. In the unlikely event
of some difficulty, please refer to the following table:
Issue Possible cause
The machine is switched off.
The machine is connected to a lower voltage.
The machine is not working.
Without tension in one or more stages.
The internal micro switch on / off the knee lever is defective or
not properly adjusted.
The sound of the motor The pressure valve is at the minimum.
rotation is heard, but the
piston does not go up or
The motor turns in the opposite direction to the correct.
down when pushing the
knee lever.
The air passage hole located at the base of the tank is
clogged.
The piston and the piston seal are dirty.
The mains voltage is not compatible with the selected for the
The piston moves up and
engine.
down but the machine
The three-phase motor (if applicable) is only running two
seems to lack strength.
phases.
There is little hydraulic oil.
There is an oil leak in the fittings or pipes.
The chambers of the hydraulic cylinder are communicated.
EN - 23
INSTALLATION AND OPERATING MANUAL
Solution
Connect the machine.
Change the voltage of the machine to the
right.
Check fuses, plugs and switches.
Contact an electrician to replace or
readjusted.
Increase pressure by turning knob clockwise.
Permute two of the three phases in the plug.
Clean it.
Clean them.
Contact an electrician to change the voltage of
the machine.
Contact an electrician to check electric grid.
Fill the oil reservoir up to "MAX"
Call your local dealer.
Call your local dealer.
V-1.3 last revision: 07/2018