Installation Of The Lid Lock Nuts And Knee Lever - Talsa F14s Mode D'emploi

HYDRAULIC PISTON FILLERS F14/25/35/50

5.2 Installation of the lid lock nuts and knee lever

Before using the stuffer it is necessary to assemble the lid lock nuts and knee lever delivered with the machine.
■
Screw the lid lock nuts on the threads projecting from the lid. Do not overtighten, as this would hinder the opening and closing of
the lid.
■
Place the knee lever at the anchor point.
■
Attach the two screws with Allen wrench supplied with the machine. Check the operation of the knee lever. It should move with little
effort and return to the center position when released (in the lifting drive the piston).
■
Place the two gray caps on the heads of the screws.
Knee lever position and action of the piston:
■
When you push the toggle to the left, the piston must rise. The knee lever automatically returns to the center position when no
pressure is applied thereon.
■
When pushing the lever rightward the piston must descend. In this position, the lever is automatically locked until the piston reaches
the lower position. The piston can be stopped at any time by pushing the lever to the center position.
It is possible to reverse the direction of drive knee lever / piston. Consult your dealer where you purchased the stuffer.
© Talsabell s.a. All rights reserved.
EN - 11
INSTALLATION AND OPERATING MANUAL
Fitting the lid lock nuts
Mounting the knee lever
V-1.3 last revision: 07/2018