Talsa F14s Mode D'emploi page 22

HYDRAULIC PISTON FILLERS F14/25/35/50
 The lid and piston of the filler are heavy as
they are made of solid stainless steel. Be
careful when removing them.
 Due to their
heavy weight,
recommended to remove the lid and piston
of the F50s between two people.
■ Pull up the key to take the piston out of the machine.
■ Disconnect the machine.
■ Proceed to clean the tank, perfectly drying the bottom in order to avoid the formation of water pockets and subsequent oxidation of the
top of the machine body. The hole at the bottom of the tank is a for water drainage.
■ Clean the piston and silicone gasket.
■ To prevent noise on the rise or lowering of the piston, lubricate the piston silicone gasket before inserting it into the reservoir, with edible fat or
other authorized USDA food.
■ To mount the piston:
 Perfectly dry the bottom of the tank.
 Place the piston in the reservoir and fully tighten the piston screw, taking care that the small seal is installed correctly.
 Then raise and lower the piston and then tighten the screw to ensure that it is secure. Otherwise it could bend when pushed against the lid.
 Lubricate the piston screw and thread before placing it. This will make disassembly easier.
■ When the machine is not in use, keep the piston at the bottom of the tank. Being immersed in the hydraulic oil will prolong the life of the rod and
seals.
We recommend the use of the following HENKEL brand cleaning and disinfecting products:
Product
Neutral degreaser with pH 7
Degreaser for manual cleaning
Alkaline degreaser with disinfectant incorporated
Disinfectant based on quaternary ammonium salts TOPAX 91
ALWAYS follow the instruction provided by the manufacturer of the product.
© Talsabell s.a. All rights reserved.
Interior cleaning
It is recommended to periodically clean the inside of piston and tank. The frequency depends on
the product (dough consistency), working pressure, etc. We recommend starting with a daily
inspection, lengthening intervals depending on their needs.
■ Fully open the lid and remove the gasket.
■ Press the knee until the piston reaches the top of its travel.
■ The piston being at the top and simultaneously pushing the knee lever, unscrew the screw
it is
located in the center of the piston with the aid of the extractor key supplied with the machine.
■ Press the knee lever so that the piston goes down a little.
■ Screw the extractor key into the thread of the piston, then press the knee lever to raise the
piston.
Name Observations
TOPAX 10 Due to its neutral pH, no special precautions are necessary. Rinse thoroughly.
RIK Use appropriate precautions and safety gear. Rinse thoroughly.
TOPAX 68 Contains corrosion inhibitors. Use appropriate precautions and wear
protection. Rinse thoroughly.
Use appropriate precautions and wear protection. Rinse thoroughly.
EN - 19
INSTALLATION AND OPERATING MANUAL
Unscrew piston
Extract piston and silicone gasket
Thoroughly dry tank bottom
V-1.3 last revision: 07/2018