Troubleshooting - Dometic eStore Instructions De Montage Et De Service

eStore
12

Troubleshooting

Problem Cause
No voltage at the The main switch is turned off
battery terminals. (open).
The fuse is defective.
eStore is in storage mode.
eStore is not configured correctly. ➤ Configure eStore.
eStore is over discharged.
eStore is defective.
Status LED does eStore is in storage mode.
not flash.
eStore is severely over
discharged.
eStore is defective.
EN
Troubleshooting
Remedy
➤ Turn on (close) the main switch.
➤ Replace the fuse (see chapter
"Changing the fuse" on
page 23).
➤ Activate eStore.
➤ Charge eStore with a charging
current of < 10 A.
Note: Do not use intelligent
charging systems (with main
swtich open, the eStore termi-
nals have no voltage. Some
intelligent battery chargers do
not start if no voltage is present).
➤ Contact an authorised work-
shop.
➤ Contact an authorised work-
shop.
➤ Activate eStore.
➤ Charge eStore with a charging
current of < 10 A.
Note: Do not use intelligent
charging systems (with main
swtich open, the eStore termi-
nals have no voltage. Some
intelligent battery chargers do
not start if no voltage is present).
➤ Contact an authorised work-
shop.
➤ Contact an authorised work-
shop.
25