Beurer HT 60 Mode D'emploi page 19

> Wind the hair around the spiral attachment [D]
towards your head. Ensure that the hair is wound as
shown in the image.
> Wait approximately 10 seconds before unwinding
the hair.
> Open the clip piece and pull the hair away from the
clip piece.
Using the straighteners
> Connect the straighteners/crimping attachment [12] to
the multi-functional styler.
> Slide the selection switch [11] to the "straighten" posi-
tion [a]. The straighteners [G] can now be used.
> Divide your hair into individual sections approximately
3 centimetres wide. Hold the hair section taut and
place between the straighteners [G] at the root.
> Slowly and evenly move the hair straighteners
from root to tip. Do not hold the hair straighteners in
the same place for more than 8 to 10 seconds. This
will achieve the best results without subjecting your
hair to excess stress or damage.
> To shape the ends, turn the hair straighteners inwards
or outwards before pulling the ends outwards.
Using the crimpers
> Connect the straighteners/crimping attachment [12] to
the multi-functional styler.
> Slide the selection switch [11] to the "crimp" position
[c]. The crimpers [F] can now be used.
> Divide the hair into individual sections. Hold the hair sec-
tion taut and place between the crimpers [F] at the root.
> Close the crimpers [F] for approximately 10 seconds.
This will achieve the best results without subjecting
your hair to excess stress or damage.
> Open the crimpers [F] and take out the hair.
> Repeat the process until you reach the tip.
19