EN
Point safety harness
Attention! Always when a child is in the stroller, even for a short period of time , always use the sa-
fety harness. Don't leave the child unattended. Always use the safety belts for in order to prevent
injuries. Join the ends of the shoulder and waist belts. Insert them in the central buckle. You must
hear a click (fig. 7)
Adjust the length of the safety belts according to child´s size and check if the buckle is locked. To
unlock the belt, press the buckle bottom (fig. 7)
Canopy
Paste all canopy´s Velcro straps to the tubes from both sides (fig. 8)
Mount both plastic clips on the canopy to the tubes of the strollerßs frame with light pressure
(fig. 9) To remove the canopy, release both Velcro straps and clips.
The canopy may be adjusted – folded and unfolded by the plastic mechanism at both sides. To
open the canopy , pull it forwards and press the mechanism down (fig.10A) as shown in fig. 10. To
fold the canopy, lift the mechanism and push backwardsl.
Front Bumper
Place the front bumper on the front tibes and press (fig.12) Press the release button at one side of
the bumper ( fig.13) and open it. This way it is easier to put the child in and out of the stroller. The
bumper will be fixed when you hear the click sound. Try to pull out the bumper in order to check if
its well attached. To detach the bumper, press the buttons at its two sides and pull it down.
Attention! Always use the safety belts in combination with the bumber when the child is in the
sroller.
Adjust the back rest
The backrest may be adjusted in 2 positions. To adjust the backrest in straight position, fasten the
two buckles of the belt on rear (fig. 14 & 15) of backrest in lower position (fig. 16)
Attention! Do not adjust the back rest while the child is in the stroller! In case the child is in the
stroller, he must be in sitting position and not leaning on the backrest, in order to prevent the
tension of child`s weight on the backrest.
Folding the stroller
CAUTION: Make sure the child is at safe distance during foling the stroller!
To fold the stroller, you must follow the below given steps:
1. Apply the parking device
2. Close the canopy
3. Put the backrest in upright position
4. Fix the wheels for straigt motion
5. Stay at the side of the handles
6. Lift up plastic pedal (fig. 17)
7. Press own locking mechanism (fig. 17) until it is released
8. Press forward and down the handles and the stroller will fold (fig. 18)