Top Bowl Cleaning Procedure - Milky FJ 600 EAR Notice D'utilisation

4. Before cleaning cream separators housing, disconnect device from mains. Clean it first
with wet duster and then try it with dry duster. Take care, that water doesn't come into
the device.
Ensure, that no water comes in contact with the motor and other electric parts.
THE DEVICE IS PROTECTED AGAINST DIRECT WATER ACCESS, PLEASE TAKE CARE
AND AVOID, THAT WATER COMES INTO THE DEVICE. BEFORE CLEANING, AL-
WAYS DISCONNECT THE CREAM SEPARATOR FROM THE MAINS SUPPLY.

TOP BOWL CLEANING PROCEDURE

With the key, which is packed with the cream separator, unscrew the top bowl fixing nut
as it is shown on the picture below.
The easiest way to perform this procedure is:
1. Fix key into the holes, which are on the top bowl fixing nut.
2. Press the key down and turn it until the fixing nut is released. It is now possible to un-
screw the fixing nut by hand.
3.
Dismount the top bowl cover with the help of the key and separate all different pieces,
which are found under the cover - plastic partition, metal discs and rubber washer. Clean
IF IT IS NOT POSSIBLE TO MOUNT OFF THE TOP BOWL FROM THE MOTOR AFTER
SKIMMING, PLEASE SHAKE IT GENTLY. PLEASE AVOID USING FORCE – IT CAN
CAUSE HARM TO THE DEVICE AND MOST OF THE PARTS.
them with hot water. To achieve better results, cleaning detergent can
be added to the hot water.
4.
Wash all the parts with hot water and dry them with dry and
soft duster.
5. Never wash the discs in the dishwasher!
21