Top Bowl Assembling Procedure - Milky FJ 600 EAR Notice D'utilisation

TOP BOWL ASSEMBLING PROCEDURES
1.
Put the rubber washer into the notch of top bowl bottom part.
2.
Place the metal discs in the top bowl. Take care with the placement of the discs - device
uses two different types of disks - plain and relief discs. First, insert relief disc, then plain
disc and repeat the procedure until all discs are placed. Avoid any use of strength while
placing the discs. With gently shaking and turning of the top bowl bottom part all the discs
will find their place very easily.
3. Put plastic partition in the top bowl cover part.
4. Place the two parts (top and bottom part) of the top bowl together. Take care that top
bowl top part marked with ˝0˝ and top bowl bottom part ˝0˝ are in the same place and
direction.
5.
Screw the top bowl fixing nut with hand and fix it strongly with the fixing key. The mark
˝0˝ must stay in the same direction. The fixing nut must be strongly fixed, because it is
exposed to high forces.
THE TOP BOWL FIXING NUT MUST BE TIGHTENED WELL, BECAUSE IT IS EXPOSED
TO CONSIDERABLE FORCES.
18
Top bowl fixing nut
Top bowl upper part
„0" marks
Plastic partition
Metal disc assembly
Rubber washer
Top bowl bottom part
„0" marks