Network settings
You can stream music from an iOS device (iPhone/iPad/iPod), an Android™ device or a PC
(Mac/Windows) to this unit by using the AirPlay or DLNA feature.
To use these features, this unit must join the same network as the AirPlay compatible
device or the DLNA compatible device.
This unit can be connected to a router using a LAN cable or built-in Wi-Fi
For a stable connection to the network, a wired LAN connection is recommended.
Note
• If you try to change the network settings immediately after turning on this unit, it may take some time until
the network setup screen is displayed.
• If "Firmware update is available" is displayed after the network connection is set up, the firmware for this
unit is available.
- For the update information, refer to the following website.
www.technics.com/support/firmware/
Wired LAN connection
Broadband router, etc.
1 Disconnect the AC power supply
cord.
2 Connect this unit to a broadband
router, etc. using a LAN cable.
12
(12)
LAN cable
(not supplied)
.
®
3 Connect the AC power supply cord to
this unit, and press [ ]. ( 11)
• When the connection is established,
"
" is displayed.
Note
• While the AC power supply cord is
disconnected, the LAN cable must be
connected or disconnected.
• Use category 7 or above straight LAN cables
(STP) when connecting to peripheral devices.
• Inserting any cable other than a LAN cable in
the LAN port can damage the unit.
• When a LAN cable is connected, the Wi-Fi
function may be disabled.