Technics Ottava f SC-C70 Manuel D'utilisation page 14

Network settings
■
Using the WAC (Wireless Accessory
Configuration)
"WAC Mode for iOS"
You can send its Wi-Fi configuration to this unit
using an iPhone/iPad/iPod touch.
• Supported devices:
iPhone/iPad/iPod touch (iOS version 7.0 or
later)
• The following explanations are based on an
iPhone.
• Make sure your iPhone is connected to your
home wireless network beforehand.
• This unit uses the 2.4 GHz frequency band
only. Check your iPhone is connected using
2.4 GHz band.
1 Press [ ], [ ] on the remote control
to select "WAC Mode for iOS" and
then press [OK].
• "Setting" is displayed.
2 Go to Wi-Fi settings on your iPhone.
3 Select "Technics SC-C70
under the "SET UP NEW AIRPLAY
SPEAKER..." on your iPhone.
• " ******
" stands for a character that is
unique to each set.
4 The "AirPlay Setup" screen appears
on your iPhone.
• This unit will be displayed as "Technics SC-
******
C70 ". To change the name, enter a
new name to replace the existing one. You
can also do the renaming after the network
connection is set up.
• You can set a password for this unit under
"SPEAKER PASSWORD". (You will need this
password if you make network settings by
internet browser next time.)
5 Select "Next" to apply the settings.
• "Linking" is displayed.
• When the connection is established,
"Success" is displayed.
- "Fail" may be displayed if the connection
was not complete. Try this method
again from [SETUP] menu. If "Fail" is still
displayed, try other methods ( 13).
6 Press [OK] on the remote control to
exit the setting.
• "
" is displayed.
Note
• Mac (OS X 10.9 or later, with AirPort Utility
6.3.1. or later) also supports the WAC (Wireless
Accessory Configuration).
14
(14)
(Continued)
"
******
■
Using the WPS button
"WPS Push"
If your wireless router supports WPS, you can
set up a connection by pressing the WPS button.
• A compatible wireless router may have the
WPS identifier mark.
1 Press [ ], [ ] on the remote control
to select "WPS Push" and then press
[OK].
• "WPS" is displayed. Complete step 2 within
2 minutes.
2 After "WPS" is displayed, press the
WPS button on the wireless router.
Example:
• "Linking" is displayed.
• When the connection is established,
"Success" is displayed.
- "Fail" may be displayed if the connection
was not complete. Try this method
again from [SETUP] menu. If "Fail" is still
displayed, try other methods ( 13).
3 Press [OK] on the remote control to
exit the setting.
• "
" is displayed.