Usage - Beurer SL 40 Mode D'emploi

8. Usage

1 Attaching the control unit to the anti snore belt
Attach the control unit to the anti snore belt
as shown in the image. Make sure that you
can hear and feel the control unit snap into
the anti snore belt at the two press studs.
2 Putting on the anti snore belt
Before putting on the anti snore belt,
first moisten the water contact elec-
trodes and the contact area on your
back with water. Apply the anti snore
belt so that the EMS electrodes are
at mid-back height. Ensure that the
anti snore belt is not cutting in, but
the EMS electrodes still have suffi-
cient contact with the skin on your
back. Make sure that the hook-and-loop fastener is securely closed.
If the anti snore belt is too short and you are unable to close it, use
the extension belt to make the anti snore belt longer.
Note
If an LED glows red, the EMS electrodes do not have sufficient con-
tact with the skin on your back. Reposition the anti snore belt until
the EMS electrodes have sufficient skin contact and the LED glows
blue. The device is only active if the EMS electrodes have sufficient
skin contact.
30