Getting Started; Operating Instruction; Card And Usb; Photo Mode - Braun DigiFrame 1060 Mode D'emploi

15. Getting Started

4.5. Place the digital photo frame with the
installed bracket in a steady flat position,
then plug one end of the AC adapter into
a standard 110-240V AC electrical outlet
and the other end into the DC IN slot on
the left side of the frame.
4.6. Slowly remove the protective film
covering the LCD.
4.7. Remove the plastic battery insulator
from the battery compartment and make
sure the remote control has a battery
inside. Please refer to "Installing &
Replacing Battery" if you need a new
battery.
4.8. It will start up automatically when the
power is on. Press the power button on
the backboard or press the Power Button
on the Remote Control to Switch On/Off.

16. Operating Instruction

After turning on the unit, a startup picture will
show. The slideshow with background music
will play automatically if there is built-In
memory, a memory card or a USB device.
NOTE: Make sure there are supported picture
and music files in the card or USB device.

10.1 Card and USB

SD/SDHC/MMC and USB 2.0 are supported.
After inserting a card or USB device, the
slideshow will play automatically, press
RETURN to access Photo, Music, Video, File,
Calendar and Setup. Press "OK" to confirm.
Note:
3) Make sure there are supported Picture,
Music and Video files in the Card or USB
device.
4) If there are supported picture and music
files in the memory card or USB Device,
the slideshow will play automatically with
background music
10.2

Photo Mode

Press "RETURN" to choose Storage Device.
Press "OK" to enter into the main menu, choose
Photo and press OK to start the slideshow, press
"Return" to enter into the 9-Pictures Mode, use
to choose the picture and press "OK"
to play. If Music is activated in the Photo setup,
the slideshow will play with background Music.
The music must be stored in the same memory
device! You can use VOL+/VOL- to turn the
volume up or down.
11