JB Systems DMX400 Mode D'emploi page 6

AS mode: program is executed according to the rythm of
•
the music and the steps will be shown on the display.
AP mode: program is executed in a constant speed,
•
adjustable by the tap sync button or the speed slider. The
steps will be shown on the display.
3. Full On and Flash
Full on = maximum output level for all channels
Flash = maximum output level for the chosen channel
4. Stand by
This button will reduce the output level of all channels to
'0' (blackout), the Led is blinking. Press it once more to exit
stand by. The Led is out.
5. Audio Input Select
You can select an audio signal from mic or audio line input.
Press prog select and turn off the power, wait a few seconds
and turn on the power, the display shows 1 or E. Press mode
select once, the audio signal will be changed and the display
will change accordingly. Press it once more, audio signal will be
changed once more. 1 = microphone, E = line input.
WARNING
To prevent fire or shock hazard, do not expose this unit to rain
•
or moisture.
This unit should be situated away from high voltage sources.
•
This unit should be connected to a power supply only of the
•
type described in the operating instructions or as marked on
the unit.
Never change the polartity of the power supply.
•
DMX 400 6