Parameter Settings - Vasco E-BANO Manuel D'utilisation Et D'installation

PARAMETER SETTINGS

From Auto, Comfort, Eco or Anti-freeze mode, press and hold the
Operating mode
Navigate through the menu with the button
setting with the or
To leave the parameter menu, choose "End" parameter and press the
Parameter
Time and day setting
5 sec
. Select a parameter with the
button and validate with the
Temperature unit
°C Celsius or °F Fahrenheit.
Default value = °C
Selection of the clock
24H (24:00) or 12H (12:00 AM /PM).
Default value = 24H
DST – Daylight summer time
If this function is activated, the thermostat changes automatically from winter to summer
time according to date.
Default value = Yes
Calibration of temperature sensor
Press the
offset has been set, display = "no".
The calibration must be done after 1 day working with the same setting temperature in
accordance with the following description:
- Put a thermometer in the room at the same distance from the floor like the thermostat.
Check the real temperature in the room after 1 hour.
- Change the measured temperature with the
real value. Now the offset is no longer "no", display with the button
- Press the
AF – Antifreeze set point temperature
Press the
freeze mode. Press the
Default value = 5°C
ITCS: Intelligent Temperature Control System
Press the
setting.
Default value = Yes
Open window detection
Press the
setting.
Default value = Yes
button:
5 sec
button.
button.
Description
button to display the measured temperature or the offset. Standard no
button to validate the calibration.
or
buttons to change the set point temperature value for Anti-
button to validate the setting.
or
buttons to change and press the
or
buttons to change and press the
Parameter setting
button. Change a parameter
or buttons in order to enter the
button to validate the
button to validate the
.
6