EUROM EK5001 Manuel D'utilisation page 32

Control panel EK9002
The EK9002 control panel consists of
two dials:
* The mode selector dial with 4
positions is located on the left.
top to bottom:
- O or off
- fan only
- 4500W power (low)
- 9000W power (high)
* The continuously adjustable thermostat dial is located on the right.
Control panel EK15002
The EK15002 control panel consists of
two dials:
* The mode selector dial with 5 positions
is located on the left.
bottom:
- O or off
- fan only
- 5000W power (low)
- 10.000W power (average)
- 15.000W power (high)
* The continuously adjustable thermostat dial is located on the right.
On the panel of the EK9002 and EK15002 also is the reset point (see Safety
features).
Location and Connection
Remove all packaging material and keep out of reach of children. After removing

packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact
your vendor for inspection or replacement.
 Select a suitable location for the device taking into account all the
aforementioned warnings in this manual.
Make sure the heater is switched off (switch to O position), then plug into a

correctly functioning, properly grounded 400V-50Hz socket. Only connect the
heater to an earthed socket!
Set-up and Operation
If the heater is being used for the first time (or if you want to reset the desired
temperature), turn the thermostat dial to the maximum position (clockwise as far
as it goes).
From
From top to
32