Cutting Capacity - Makita 2414NB Manuel D'instruction

1
2
3
4
► 1. Guide plate 2. Straight piece of wood (Spacer)
3. Over 45 mm (1-3/4") long 4. Over 65 mm
(2-9/16") long 5. Over 190 mm (7-1/2") long
If you use a spacer block which is slightly narrower
than the workpiece as shown in the figure, you can also
utilize the wheel economically.
5
► 1. Diameter of workpiece 2. Guide plate 3. Spacer
block 4. Width of spacer block 5. Vise
Long workpieces must be supported by blocks of
non-flammable material on either side so that it will be
level with the base top.
► 1. Blocks
5
1
2
3
4
1
OPERATION
Hold the handle firmly. Switch on the tool and wait until
the wheel attains full speed before lowering gently
into the cut. When the wheel contacts the workpiece,
gradually bear down on the handle to perform the cut.
When the cut is completed, switch off the tool and WAIT
UNTIL THE WHEEL HAS COME TO A COMPLETE
STOP before returning the handle to the fully elevated
position.
CAUTION:
• Proper handle pressure during cutting and maxi-
mum cutting efficiency can be determined by the
amount of sparks that is produced while cutting.
Your pressure on the handle should be adjusted
to produce the maximum amount of sparks. Do
not force the cut by applying excessive pressure
on the handle. Reduced cutting efficiency, pre-
mature wheel wear, as well as, possible damage
to the tool, cut-off wheel or workpiece may
result.

Cutting capacity

Max. cutting capacity varies depending upon the cutting
angle and workpiece shape. Applicable wheel diameter:
355 mm (14")
Workpiece
shape
Cutting
angle
90°
45°
Workpiece
shape
Cutting
angle
90°
115 mm x 103 mm
45°
(4-1/2" x 4-1/16")
7 ENGLISH
115 mm (4-1/2") 119 mm (4-11/16")
115 mm (4-1/2") 106 mm (4-3/16")
115 mm x 130 mm
(4-1/2" x 5-5/8")
102 mm x 194 mm
137 mm (5-3/8")
(4" x 7-5/8")
70 mm x 233 mm
(2-3/4" x 9-1/8")
100 mm (3-15/16")