Metabo C 18DBAL Instructions De Sécurité Et Mode D'emploi page 18

English
Loosen
Loosen
Incline lever
Incline wing-nut
Tighten
Incline lever
Always ensure that the wing-nut is thoroughly
tightened after making the desired adjustment.
NOTE
Values of the inclined gauge provided on the base
merely serve as a rough guideline. For cutting
operation at an inclined precise angle, use the circular
saw after adjusting the angle between the base and
the saw blade with a protractor, etc.
3. Fine tuning of parallelism
It is possible to fi ne-tune the parallelism of the saw
blade to the base using the parallelism adjustment
screw.
Adjustment has already been made at the time of
shipment from the factory. However, in the unlikely
event of parallelism being faulty, adjust as follows.
18
Incline wing-nut
A
Stopper lever
Fig. 16
Tighten
B
Stopper lever
Fig. 17
(1) Unfasten only the mounting screws of the saw cover
hinge portion (Fig. 18).
5
(2) Retract the lower guard into the saw cover.
(3) Insert wood chip in the rear side of the saw blade
base, and mark the position on the base (Fig. 19).
(4) Move the marked wood chip to the front of the base,
and turn the parallelism adjustment screw so that the
marking corresponds to the base side (Fig. 20).
NOTE
After parallelism adjustment, if the saw cover hinge
portion is loose, tighten the M5 U-Nut. Do not over
tighten the nut as this may result in deformation of the
bevel plate.
Fig. 18
Fig. 19
Fig. 20