EHEIM 1250 Mode D'emploi page 8

English
Thank you
for puchasing your new EHEIM pump that provides optimum performance
with maximum safety and reliability.
Safety instructions
All electrical equipment in the water must be disconnected from the mains
during care and maintenance work.
The connecting line of this device can not be replaced. When the line is da-
maged, the device must no longer be used. Never carry the pump by the cable;
do not bend the cable.
The pumps may only be used in garden ponds and their area of protection if
installed according to prevailing regulations. As a means of protection against
overly high shock hazard voltage, the installation must show a leakage current
safety guard with a rated residual current of no more than 30 mA. Please con-
sult your electrician.
This equipment is not intended for use by persons (including children) with li-
mited physical, sensory or mental abilities or for persons with no experience
or knowledge unless they are supervised by a person responsible for safety or
unless they have received from such a person instructions on how to use the
equipment. Children should be supervised to ensure that they do not play with
the equipment.
Notice: These divices produce magnetic fields which might cause
20 cm
electronic and mechanical disturbances or damages. This also re-
fers to pacemakers. Please consult the manuals of medical equipment for the
required safety margins.
Attention: Maintenance work presents the risk of crushing the fingers due to
high magnetic forces.
Do not dispose of this product as normal household waste. Take it to your local
refuse collection site.
The product is qualified in accordance with the respective national regulations
and guidelines and meets EC standards.
geprüfte
Sicherheit
Universal Pump 1250019 - 1250209
Model: see type plate on pump housing
Function
A Motor body
stops pump parts
grille threaded adaptor, suction side
The pump can be used both in and out of the water. It is not self-priming and
to operate, must therefore be positioned on the outside of the tank – below
the water level.
Putting into operation
To make it operate, suck briefly at the end of the pressure hose, until water
flows to the pump. Do not insert power supply plug until you have done this.
A brief noise when the pump starts up is normal. For outdoor installation.
– suitable for outdoor use –
fixing strip threaded adaptor, pressure side
clamping ring coarse filter suction
cap.