Toe-Kick
The Toe-Kick itself can be removed for service or
cleaning (see "Cleaning behind the Toe-Kick" in the
next section).
1. Remove the stainless steel Toe-Kick by unscrewing
and removing the two front screws with a Philips
screwdriver.
Front screws
2. You can remove the Toe-Kick by simply pulling it
out of the left and right mounting brackets.
3. To reattach the Toe-Kick, slide over the left and right
mounting brackets, such that bottom tabs of the Toe-
Kick rest on top of the bracket bases. This will allow
the Toe-Kick and mounting bracket screw holes to align.
Bracket bases
Bottom tabs
Page |10
Cleaning the appliance
WARNING:
Never clean the appliance with a steam cleaner!
CAUTION:
• Do not use abrasive or acidic cleaning agents and
solvents.
• Do not use scouring or abrasive sponges. The
metallic surfaces could corrode.
• Never clean the glass shelves in the dishwasher. The
parts may be damaged.
Proceed as follows:
1. Before cleaning: switch the appliance off. For
instructions, see "Off Mode" section on the "Special
Functions" page.
2. Clean the appliance, and the glass shelves with a
soft cloth, lukewarm water and a little pH neutral
detergent.
3. Clean the appliance with a soft cloth,
lukewarm water and a little pH neutral detergent.
4. W ipe the drawer seals with clear water only and
then wipe dry thoroughly.
5. After cleaning switch the appliance back on.
CAUTION:
When rinsing the cabinet, water must not enter the
interior light recess located on the upper side of the
interior cabinet, or spill out from the bottom of the
cabinet.