Technical Data - Hilti TE 60 Mode D'emploi

4 Technical data

Right of technical changes reserved.
NOTE
The power tool is available in various voltage ratings. Please refer to the type identification plate for details of the
power tool's voltage and power rating.
Power tool
Rated power
Rated voltage / rated current
Mains frequency
Weight in accordance with EPTA procedure 01/2003,
TE 60
Weight in accordance with EPTA procedure 01/2003,
TE 60‑ATC‑AVR
Dimensions (L x W x H), TE 60
Dimensions (L x W x H), TE 60‑ATC‑AVR
Hammer drilling speed
Single impact energy in accordance with the EPTA pro-
cedure 05/2009 (full power setting)
Single impact energy in accordance with EPTA proced-
ure 05/2009 (half power setting), TE 60‑ATC‑AVR
NOTE
This equipment complies with the applicable standard provided that the maximum permissible mains supply impedance
(Zmax) at the point where the user's installation is connected to the public supply network is less than or equal to
0.378+j0.236 Ω. It is the responsibility of the installer or user of the equipment to ensure, by consultation with the
supply network operator if necessary, that the equipment is connected only at a point in the supply with an impedance
of less than or equal to Zmax.
Other information about the power tool
TE 60 / TE 60‑ATC‑AVR chuck
Protection class as per EN
NOTE
The vibration emission level given in this information sheet has been measured in accordance with a standardized test
given in EN 60745 and may be used to compare one tool with another. It may be used for a preliminary assessment
of exposure. The declared vibration emission level represents the main applications of the tool. However if the tool is
used for different applications, with different accessories or poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total working period. An estimation of the level of exposure to
vibration should also take into account the times when the tool is switched off or when it is running but not actually
doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety
measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep
the hands warm, organization of work patterns.
Noise and vibration information (measured in accordance with EN 60745‑2‑6):
Typical A‑weighted sound power level for the TE 60
with ATC and AVR
Typical A-weighted sound power level, TE 60
Typical A-weighted emission sound pressure level for
the TE 60 (with ATC and AVR)
Typical A-weighted emission sound pressure level,
TE 60
Uncertainty for the given sound level
TE 60 / TE 60‑ATC‑AVR
1,300 W
Rated voltage 110 V: 14.8 A
Rated voltage 230 V: 6.9 A
50...60 Hz
6.4 kg
7.7 kg
480 mm x 115 mm x 274 mm
490 mm x 115 mm x 293 mm
350/min
7.3 J
3.6 J
TE‑Y
Protection class II (double insulated)
112 dB (A)
107 dB (A)
101 dB (A)
96 dB (A)
3 dB (A)
en
19