Ca Re R Ec O M M En D Ations - Wolf ICBWWD30 Guide D'utilisation Et D'entretien

Masquer les pouces Voir aussi pour ICBWWD30:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14

CA RE R EC O M M EN D ATIONS

Care Recommendations
C L E A NI N G
Stainless steel
Use a nonabrasive stainless steel cleaner and apply with a soft lint-free cloth. To bring out the natural
luster, lightly wipe surface with a water-dampened microfiber cloth followed by a dry polishing chamois.
Always follow the grain of stainless steel.
The stainless steel drawer pan is removable for cleaning. To remove, open drawer completely. Slide finger-
tips under side edges of pan, pull up and out.
Control panel
Use a spray degreaser to remove fingerprints and food soil. Spray on a cloth before wiping panel.
Do not spray cleaners directly on the control panel.
Removable Rack
Clean with hot water and mild detergent or paste of baking soda and water. Towel dry.
Interior
Wipe with a soft damp cloth. Do not use abrasive or harsh cleaners or scouring pads. For heavier soil, use
baking soda or a mild soap; rinse thoroughly with hot water.
Drawer Guides
Remove food crumbs from drawer guides. Wipe with a soft dry cloth.
|
6
English
TRO U BL E S HO O T ING
Troubleshooting
Warming drawer does not operate.
Verify power is on.
Verify electrical power to warming drawer and home
circuit breaker is on.
Drawer does not slide smoothly.
Drawer is out of alignment. Fully extend the drawer and
close completely to realign.
Drawer is overloaded. Reduce weight to less than 27 kg.
Redistribute contents to balance load.
Excessive condensation.
Remove liquid in drawer pan.
Cover food with lid or aluminum foil.
Temperature setting is too high. Use lower setting.
No heat in proof setting.
Verify PROOF is illuminated on the control panel display.
Room temperature may prevent thermostat from turning
on.
Food dries out in proof setting.
Cover food with lid or aluminum foil.
S ERV IC E
Maintain the quality built into your product by contacting
Wolf factory certified service.
When contacting service, you will need the model and
serial number of your product. Both numbers are listed
on the product rating plate. Refer to page 4 for rating
plate location.
For warranty purposes, you will also need the date of
installation and name of your authorized Wolf dealer. This
information should be recorded on page 2.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Wwd30o

Table des Matières