Fender BASSBREAKER 30R Mode D'emploi page 3

Using two speaker enclosures of different impedance ratings is not rec-
ommended. If using enclosures with different ratings, set IMPEDANCE
SELECT switch (P) to the lower of the two speaker enclosure ratings.
When using both speaker jacks, do not use an enclosure rated at less
than 4Ω. When using MAIN SPEAKER jack alone, do not use an enclo-
sure rated at more than 16Ω.
Q. PARALLEL SPEAKER OUTPUTS: Connect external speaker enclosures
here. To avoid damage, turn the amplifier off when changing speaker
connections. Use an external speaker enclosure in combination with the
internal speaker by plugging external enclosure into EXTENSION SPEAK-
ER. To use an external speaker enclosure only, plug external enclosure
into MAIN SPEAKER (internal speaker will automatically be disconnected).
Use the MAIN SPEAKER jack when using only one enclosure (there will
be no sound if the MAIN SPEAKER jack is not used). See table below for
acceptable parallel speaker enclosure impedance combinations.
Bassbreaker 30R acceptable parallel speaker enclosure impedance
combinations with correct IMPEDANCE SELECT switch (P) settings:
INTERNAL SPEAKER MAIN SPEAKER EXTENSION SPEAKER
8Ω NONE
8Ω NONE
DISCONNECTED* 16Ω
DISCONNECTED* 8Ω
DISCONNECTED* 4Ω
DISCONNECTED* 16Ω
DISCONNECTED* 8Ω
*NOTE: When a plug is inserted into MAIN SPEAKER jack, internal speaker load (8Ω) is
automatically disconnected and does not affect total impedance load.
TYPE
POWER
IMPEDANCE
SPEAKER
EXTERNAL SPEAKER ENCLOSURE
TUBES
FOOTSWITCH
COVER
DIMENSIONS AND WEIGHT
IMPEDANCE SELECT
NONE 8Ω
8Ω 4Ω
NONE 16Ω
NONE 8Ω
NONE 4Ω
16Ω 8Ω
8Ω 4Ω
SPECIFICATIONS
PR 5265
Requirements: 175 watts
1MΩ
12" Celestion® V70 S6125 (8Ω, PN 7700343000)
Bassbreaker BB-112 (optional, PN 226700000), Bassbreaker BB-212 (optional, PN 226800000)
V1-V3: 7025/12AX7A/ECC83
2 button gain/channel (included, PN 0079606000)
Fitted cover (included, PN 7713347000)
Width: 24" (60.96 cm) Height: 18.5" (46.99 cm)
Product specifications subject to change without notice.
R. FOOTSWITCH: For use with included two-button footswitch.
Footswitch overrides CHANNEL TWO (E) and HI GAIN (G) switches on
amp control panel.
S. EFFECTS LOOP: Optimized for use with pedals. Connect SEND to
effects input and RETURN to effects output.
T. CABINET EMULATION: Pushbutton switch sends a speaker-emulated
signal through the DIRECT OUT (V) to recording and sound reinforcement
equipment (instead of preamp-only signal).
U. GROUND LIFT: Pushbutton switch helps eliminate unwanted electrical
noise associated with ground loops.
V. DIRECT OUT: High-quality XLR output sends preamp signal for record-
ing and sound reinforcement use.
For questions and troubleshooting, contact a
Fender specialist at:
1-800-856-9801 (U.S. toll free)
1-480-596-7195 (International)
Output: 30 watts into 16Ω/8Ω/4Ω
V4-V7: EL84
Depth: 10" (25.4 cm) Weight: 38 lbs. (17.24 kg)
3