Elica SEE YOU BL/A/90 Instructions De Montage, D'utilisation Et D'entretien page 12

CAUTION! Fixing screws and fixing devices
shall be installed according to the instructions
given in this manual; failure to comply with them
might result in electric risk .
The manufacturer declines all responsibility for
any inconvenience, damage or fire caused by
the appliance, due to failure to comply with the-
se instructions.
Constantly seeking to improve our products, we
reserve the right to modify their technical, fun-
ctional, or aesthetic characteristics as a result of
their upgrading.
In the case of external motor version , for the
hood normal operation, it is necessary to use
a suctioning unit (external motor) made by the
same manufacturer.
This appliance is marked according to the Euro-
pean directive 2012/19/EC on Waste Electrical
and Electronic Equipment (WEEE By ensuring
this product is disposed of correctly, you will
help prevent potential negative consequences
for the environment and human health.
The symbol on the product or on the do-
cumentation included with it, means that this
product shall not be disposed of as household
waste. Instead it shall be handed over to the su-
itable collection point for the recycling of electri-
cal and electronic equipment. The product shall
be disposed of according to applicable local
standards and regulations on waste disposal.
For more detailed information on the disposal
and recycling of this product, please contact
your local city office, your household waste di-
sposal service or the shop where you purcha-
sed the product.
This appliance has been designed , tested and
produced in compliance with all relevant stan-
dards on :
• Safety: CEI/EN 60335-1; CEI/EN 60335-2-31,
CEI/EN 62233.
• Performance: CEI/EN 61591; ISO 5167-1; ISO
5167-3; ISO 5168; CEI/EN 60704-1; CEI/EN
60704-2-13; ISO 3741; EN 50564; CEI 62301.
• EMC: EN 55014-1; CISPR 14-1; EN 55014-2;
CISPR 14-2; CEI/EN 61000-3-2; CEI/EN
61000-3-3.
Tips for the proper use of the appliance, aimed
at reducing environmental impact.
Switch the hood on at minimum speed when
you start cooking and leave it in operation for
some minutes after you finish cooking. Increase
the speed only in case of high quantities of fu-
mes and vapours, using the boost feature only
when absolutely necessary.
In order to keep the odour reducing system
efficient over time, replace the charcoal filter/s
whenever necessary.
In order to keep the grease filter efficient over
time, clean it whenever necessary.
Use a piping system with the maximum diame-
ter specified in this manual, in order to reach
very high performances and maintain low noise
levels.
Use
The hood can be used both in aspiration mode
with external discharge of suctioned air, and in
filtering mode, where the air is recycled back
into the room.
Aspiration Mode
Vapours are discharged to the outside, through
the specific exhaust pipe fixed to the flange.
The exhaust pipe diameter shall be the same as
the connection ring diameter.
11