Epson EB-W16SK Guide De Démarrage page 9

Caution
When attaching the
commander to the
receiver, be careful not to
trap your fingers.
Attach the commander to the receiver. Place the commander's screws
into the gap in the receiver's mount, and then tighten the screws. (on the
left and right)
D Secure the stacker angle adjustment section with screws.
There are screw holes
numbered 1 to 4 on
the left and right of the
stacker mount.
You can change the
commander's projection
angle by changing the
position secured by the
screw.
Place the screws into the holes, and then tighten them. (on the left and
See "Screen Size and
right)
Projection Distance" on
page 18 to determine which
screw hole to use.
E
Stick a marking
sticker on the
position where the screw
is secured. You can then
use these marks (on the
left and right) when
reassembling.
Remove the clear protective film
from the polarizers.
Remove the protective
film from the polarizers.
9 9 9 9 9