Epson EB-W16SK Guide De Démarrage page 14

Projecting
Images
Superimposing the
images from the
commander and the
receiver
Superimpose two
images. Perform after
setting up.
A Open the A/V mute
slides.
Open the A/V mute slides on the
commander and the receiver.
14 14 14 14 14
■
When suspending the
projectors from a
ceiling, change the
Commander frame
Projection mode before
superimposing the images.
You can change the
Projection mode by
holding down the [A/V
Mute] button on the
remote control for about
five seconds.
B Turn on the projectors.
Press the [ ] button on the
commander's control panel.
The commander and the receiver
turn on.
Superimposing Images
Receiver frame
(white) (green)
• Pressing buttons on the control panel operates the
commander and the receiver. Perform projector
operations from the commander's control panel.
• The following icon is displayed when turning on. The
projector indicated by the arrow is the subject of the
displayed message.
Commander
Receiver
Adjusting the Focus
Match the focus for the commander and the receiver.
Determining the size of the receiver's frame
Adjust the receiver's projection size to fit the screen.
Surrounding the receiver's frame with the
commander's frame
Adjust the commander's frame (white) so that it is outside the
receiver's frame (green).
The screens fit together.
C Display the screen
to adjust the
superimposed images.
Hold down the [Screen Fit]button
for about five seconds.
The adjustment top screen is
displayed.
Approx.
five seconds