Atlantic Galapagos Notice D'utilisation Et D'installation page 29

You can program your Comfort
by connecting the pilot wire to a programming control (Pilot wire (FP) mode is the default setting - refer to your programming
control's manual).
You can connect several devices to one programmer.
3 programs have been prestored:
0h 1h 2h 3h 4h 5h 6h 7h 8h 9h 10h 11h 12h 13h 14h 15h 16h 17h 18h 19h 20h 21h 22h 23h
is recommended for when you are constantly at home, at the weekend for example (Eco mode from 23h to 5h,
Comfort mode from 5h to 23h).
is recommended if you are absent during the day (Eco mode from 23h to 5h and from 9h to 17h, Comfort mode
from 5h to 9h and from 17h to 23h).
is recommended if you are absent during the day, but you come back home at lunchtime (Eco mode from 23h to
5h, from 9h to 12h and from 14h to 17h, Comfort mode from 5h to 9h, from 12h to 14h and from 17h to 23h).
means that a programming control is used.
NB : If no command is received on the pilot wire, the device will function in Comfort mode.
When switching from Comfort to Eco mode, the new mode is active after about 12 seconds.
The Frost Protection and Load shedding commands have priority over the Eco, Comfort and programming (P1, P2, P3 and
) modes.
PROGRAMMING THE HEATING PERIOD
HOW TO USE
D
ESCRIPTION
and temperature times either by using one of the three prestored programs, or
, and and they cannot be changed.
P
PROG
ROG MODE
28
: