Calibrate The Temperature; Returning To The Standard Factory Settings; Maintenance; Specific Gravity Of The Coolant Contained In The Device - Atlantic Galapagos Notice D'utilisation Et D'installation

Depending on your installation, the temperature you read may be different to the one displayed on your device. In that
case, you can calibrate the temperature displayed.
Hold the following keys down si-
multaneously:
- Programming (C),
- Power on (E).

Returning to the standard factory settings

It is possible de return to the standard settings for your device.
Hold the following keys down si-
multaneously
- Aeration (B),
- Settings (C),
- Scroll (E),
until everything is displayed on
the screen (see page 24 for the
different displays).
To maintain your device's performance, you must dust it approximately twice a year.
Never use abrasive products or solvents.
This device is filled with a precise amount of coolant. This fluid does not deteriorate and requires no particular mainte-
nance. Any repairs requiring the coolant reservoir to be opened, must only be performed by a professional, the manufac-
turer or its After-Sales service. The latter must be contacted in the event of a leak.
When the device is scrapped, the coolant must be disposed of only at an authorised waste coolant collection depot.

Calibrate the temperature

C
C
B

Maintenance

Specific gravity of the coolant
contained in the device
With the + (D) or - (F) keys, choose your
calibration value (between -2°C and 2°C).
E.g.The temperature displayed on your device is
E
20°C.
The temperature displayed on your thermome-
ter is 19°C -> Choose a calibration value of -1°C.
Confirm your choice by pressing the Programming
key (C). Your device will heat until the room tem-
perature reaches 20°C.
The device switches to Comfort
E
19°C. The
saving and programmed functions are deacti-
vated.
34
D
F
mode at
mode is at 15.5°C. The energy