These are located on the left-hand side of the device.
The commercial code and the serial number identify for the manufacturer the particular device you have bought.
Devices with this symbol must not be scrapped with normal household rubbish but be collected separately and
recycled.
When these products come to the end of their useful life, they must be collected and recycled in accordance with
the local regulations and bylaws.
Classification of the device :
CAT C :
Complies with EU standards for this category.
IP24 :
Protected against water projections.
Classe II :
Dual insulation.
- Please ensure that children do not lean on the device or play close to it when it is operating : its surface may be hot en-
ough to cause burns to their skin in some circumstances, particularly because their reflexes may not yet have been ac-
quired or aur slower than those of an adult. If there is any risk, fit a protective grill in front of the device.
- This device is not intended for use by persons (including children) with physical, sensory or mental disability, or by per-
sons lacking experience or knowledge, unless they have received from a person in charge of their safety adequate su-
pervision or preliminary instructions on how to use the device.
- Care must be taken at all times to keep children from playing with the device.
- If the supply cord is damaged, it must be replaced by a service agentor similarly qualified person in order to avoid a ha-
zard (applies to units fitted with a supply cord and plug).
- Units fitted with a three core supply cord (brown, blue and black), must be directly connected to hard wiring by a licen-
sed electrician.
- All work on the interior of the device must be carried out by a licensed electrician.
- Do not cover the device : otherwise the device may overheat.
- When it is first switched on, the device may give off a slight odour. This is not the result of any fault in the device and the
odour will dissipate after a few minutes. If necessary, air the room until the odour dissipates.
We strongly advise against installing vertical machines above an altitude of 1000m
(risk of faulty operation).
Installing a machine at altitude causes an increase in air output temperature
(of the order of 10°C per 1000m above sea level).
It is forbidden to install a vertical machine horizontally or vice versa.
Do not use the device in mobile, on feets or on casters.
The references for your device
Warning
A
Standards, quality labels
B
Commercial name
C Commercial code
D Manufacturing reference
E
Serial number
F
Manufacturer's number
20