Operation; Fitting - TOOLCRAFT T-WS125 900W Notice D'emploi

7. Operation

a) Fitting
Fit the additional hand grip
• See figure B.
• The additional handle can be attached on the left [1] or o n the right [2] of
the product.
• Screw the additional hand grip firmly into the threaded hole on the appliance.
Permissible grinding tools
• The permissible maximum rpm or cutting speed of the abrasive bodies used must comply with the details in the
table below.
• Therefore please observe the permissible rpm or peripheral speed on the label of the abrasive body.
• Always use the intermediate layers enclosed with the abrasive bodies: they are positioned between the abrasive
body and the clamping flange and must be at least the same size as the contact surfaces of the flanges.
• When using abrasive bodies with threaded inserts, it must be ensured that the end of the spindle never touches the
perforated plate of the grinding tool.
• Abrasive bodies with threaded insert must be able to be screwed onto the grinding spindle far enough that they
firmly fit the grinding spindle flange at the end of the grinding spindle thread.
Fitting the abrading disc
Risk of injury! Never use damaged abrading discs. Always check the abrading disc for cracks or other
damage before fitting it. Use only abrading discs whose permitted rotational speed is at least as high as the
idling speed of the appliance.
Risk of injury! The permitted diameter for the abrading disc must always be complied with.
Risk of injury! Use only abrading discs which are permitted for the material being worked with.
• See figure C.
• Press the spindle locking button on the top of the tool and keep it pressed.
• Unscrew flange nut (7).
• Place the abrading disc onto the spindle. Comply with the required
installation position of the abrading disc.
• Place the flange nut onto the spindle.
• Note the installation position of the flange nut:
• Flange pointing away from abrading disc: for thin discs such as cutting discs.
• Flange pointing towards abrading disc: for thicker discs such as abrading
discs.
• Tighten the flange nut using the face pin wrench provided while pressing the
spindle locking button.
24
1
Fig.B
1
7
Fig.C
2
2