Commissioning; Operation; Switching On/Off - TOOLCRAFT T-WS125 900W Notice D'emploi

b) Commissioning
• See figure A.
Adjusting the protective bonnet
The protective hood must be adjusted so that it prevents sparks and particles from being thrown in the direction of
the user.
• Loosen bolt (5).
• Adjusting the protective hood
• Retighten bolt (5)
c) Operation
Risk of injury! Let the appliance idle for a few seconds before use. When vibrations start to occur, replace
the abrading disc immediately.
Risk of injury! The appliance must be used only with the additional hand grip fitted and the protective hood
correctly adjusted.
Check before switching on
Check the safe condition of the appliance:
• Check it for visual defects.
• Check that all parts of the machine have been securely fitted.

Switching on/off

Risk of injury!After switching off, the appliance continues to run on for a few seconds. Waiting until the
abrading disc has come to a stop before laying the appliance down.
In case of a loss of power, an under-voltage relay triggered. This prevents the product from restarting by
itself as soon as the power is restored.
• See figure D.
• To switch on again the product must be turned off at the main switch and
then turned back on.
- Switching on: Press the On-Off switch (1), at the same time, slide forwards
and allow it to engage in position [1].
- Switching off: Press the On-Off switch (1) briefly and allow it to glide back
to position [0].
2 1
Fig.D
25