Blaupunkt BLP1900SP.COMP Mode D'emploi page 16

If you have two of these Bluetooth Speakers, you can use them together as 2.0 stereo speakers.
Be sure neither speaker is paired to a device before you connect them together.
Press and hold the "Play/Pause" button to disconnect the speaker from the current device and
reset it into pairing mode. Please make sure the 2 speakers are not placed more than 5 meters
from each other when paring.
1. Press the "Power" button to turn on speaker number 1.
2. Press and hold the "Play/Pause" button to enter the Stereo Pairing mode.
3. The blue indicator light will blink quickly.
4. To pair the speakers together, next you need to press the "Power" button to turn on speaker
number 2.
5. Speaker 2 will automatically search for the other speaker and connect with it.
6. When the speakers are connected the blue indicator light on the speaker number 1 will blink
quickly and the 2nd speaker will blink steadily.
7. To connect your device to these two speakers, you will need to turn on the Bluetooth function
of your device.
8. Search for "BLP1900" on the wireless list and then pair with it. If you need to input a pairing
code, use 1234 or 0000.
9. The indicator light of the number 1 speaker will blink slowly after the pairing is successful.
10. To turn off the True Wireless Stereo mode, press and hold the "Play/Pause" button of any of
the speaker.
Charging
Connect the USB cable to an USB power adapter or an USB port of the computer, and then plug
the micro USB into the micro USB port of the speaker. While charging, the indicator light is
always in green. When it is full charged, the indicator light turns off.
Wireless charging (optional) : this speaker supports wireless charging. You can put the speaker
on the top center of the wireless charging pad. It will be charged automatically. While charging,
the indicator light is always in green. When it is full charged, the indicator light turns off. Please
make sure your wireless charging pad has been connected to the USB cable and the other side
of the USB cable had been plugged into the USB power adapter.
NOTE: If there is no connection within 10 minutes after power on, the speaker will automatically
power off.
Declaration of conformity UE
Dag Technologie®, herby declares that this equipment, conforms to the essential requirements
and other relevant provisions of Directive 2014/53/UE. The declaration of Conformity can be
viewed at the following address:
http://www.mms-support.net/OTA/ECD_DAG_BLP1900SP.COMP.pdf