Tools Needed For The Assembly; Your 2 Channel Radio System - Carson Helldevil Notice D'emploi

5. Tools needed for the assembly

aaaaaaaaaaaaaaaaaaaaaaac
Modelling knife
Philips screwdriver (small and big)

6. Your 2 channel radio system

aaaaaaaaaaaaaaaaaaaaaaac
Please read the instructions provided with your radio system before using it.
The servos must be set at the centre position before installation. To set the
servos at a neutral position, turn on the transmitter and receiver. Set the trim
levers in the center position and turn off the receiver, and then the transmitter.
The servos will be in proper neutral position for installation.
Batteries for receiver
Steering servo
6
Instant adhesive
Hexagonal wrench
Receiver
Receiver antenna
Engine throttle servo
Needle nose pliers
Tool kit
Transmitter
Switch
Scissors
Side cutter
Transmitter antenna