Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
1d
1
x 4
2
x 4
64mm
(2-1/2")
3
4
Concrete Installation
NOTE:
CPA adapter must be removed prior to installing
RSME to concrete. See Section 1a for details.
1.
Determine mounting location.
WARNING:
a concrete ceiling with a minimum thickness of 8" and a
maximum drywall covering of 5/8".
WARNING:
RESULT IN SERIOUS PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! Structural members MUST
be capable of supporting five times the combined weight
of all equipment being mounted.
2.
Using the RSME as a guide, mark four mounting hole
locations on ceiling using a pencil or similar tool.
Ø 6.3mm
(Ø 1/4")
3.
Drill four 1/4" (6.3mm) dia. pilot holes to a depth of
2-1/2" (64mm) deep.
4.
Align four mounting holes in RSME with four pilot
holes.
IMPORTANT ! : Make sure mount is properly
oriented towards target before securing to
structure.
WARNING:
into structurally sound solid concrete. Installation into
x 4
hollow concrete block, mortar, or concrete that exhibits
cracking, spalling, or other defects may result in failure
5
of anchor and serious personal injury or damage to
equipment.
5.
Install four 3/8" x 2-1/4" concrete anchors (not
(A)
included) by inserting into pilot holes and pounding in
until flush with mounting surface.
6.
Secure RSME to structure using four #10 flat washers
and four #10 x 3" Phillips head wood screws (not
included).
x 4
6
The RSME is designed to be mounted to
IMPROPER INSTALLATION CAN
Anchors (not provided) must be installed
RSME
9
Publicité
Table des Matières
