Safety Information; Ordering Spare Parts - EINHELL BT-TW 150 Instructions De Montage

Anleitung_BT_TW_150_SPK1:_
Important.
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety information with due care. Keep this manual in
a safe place so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and the safety
information as well.
We cannot accept any liability for damage or
accidents which arise due to a failure to follow these
instructions and the safety information.

1. Safety Information

CAUTION
Read all the safety regulations and instructions.
Any errors made in following the safety information
and instructions set out below may result in serious
injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Machine description and items
supplied (Fig. 1/2)
1. Tool trolley
2. Keys
3. Wheels
4. Emergency release
5. Lock
6. Handle
3. Starting up
The keys (2) for the tool trolley (1) are in two
different places. One is attached to the packaging
of the tool trolley, the other to the instructions for
the tool trolley.
Please keep the keys safe in different places, but
NEVER in the tool trolley.
After transportation and/or assembly make sure
that all drawer compartments are completely
closed.
For safety reasons the tool trolley is equipped
with pull-out stops for the drawers. This prevents
several drawers being opened at the same time.
04.05.2010 16:36 Uhr Seite 7
4. Assembly
Important. To avoid malfunctions, please note
that all the drawers must be COMPLETELY closed
before you pull one out!
The handle (6) supplied with the equipment is
already fitted but can also be mounted on the
other side of the trolley (Fig. 2).
For details of how to mount the wheels (3), please
refer to Figure 3 and turn the tool trolley on its top.
If problems arise with the drawers, please refer to
the following instructions:
What to do if,
a drawer cannot be closed properly:
Lock and unlock the lock until you hear a loud
"click".
Open a second drawer and then close both
drawers simultaneously or
Activate the emergency release (4). This is done
by moving the emergency release on the
underside of the tool trolley. This will release the
lock on the tool trolley (see Figs. 4 - 6).
none of the drawers can be opened, although the
lock is not locked:
Lock and unlock the lock until you hear a loud
"click".
Activate the emergency release (4) (see Figs. 4 -
6).

5. Ordering spare parts

Please provide the following information on all orders
for spare parts:
Model/type of the equipment
Article number of the equipment
ID number of the equipment
Part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
The spare part number of the key can be found on the
flat face of the key and on the lock (Fig. 7/8)
GB
7