Alecto WS-3300 Guide De L'utilisateur page 40

Wind Direction:
The wind direction is indicated in the compass card. If the outdoor wind sensor is installed correctly the wind
direction is indicated (see 3.2 To set the wind meter).
Wind Chill:
On cold days and windy days it's not the temperature that makes it cold, but the combination of the amount
of wind and the temperature. When the outdoor temperature falls below 10°C and the wind speed is above
4.8 Km/h, the wind chill is indicated. The display shows "--.- °C" outside this value.
6.8 RAIN MEASUREMENTS:
The display shows the following rain measurements:
Total:
This shows the total amount of rainfall from the beginning (last reset or battery placement) until now.
Press the "RAIN SINCE" (34) button to check the starting date.
The date will be shown instead of the clock.
Today:
This shows the rainfall of today (the last 24 hours).
Rain History:
Press the "RAIN HISTORY" (27) button to view the rainfall history up to 30 days ago. The history disap-
pears from the display after 15 seconds without pressing any button.
To delete the rainfall data:
Press and hold the "RAIN CLEAR" (34) button for 2 seconds to delete the rainfall data.
Rainfall alert function:
When a certain amount of rain has fallen, the weather station can be set to emit an acoustic alert signal.
To set the rainfall alert:
Press and hold the "RAIN ALERT" (37) button for at least 2 seconds.
"HI" starts flashing. Use the ▼ and ▲ buttons to select the desired rainfall alert level and press the "RAIN
ALERT" (37) button to confirm the value.
Press the "RAIN ALERT" (37) button to activate or deactivate the rainfall alert ("HI" appears in the display
when the rainfall alert is enabled).
The alert starts as soon as the rainfall level is reached.
Press any button to stop the alert (the "HI" icon remains flashing).
6.9 TEMPERATURE:
Indoor and Outdoor TEMP:
Indoor and outdoor temperature with humidity (when the humidity is below 20%, the ▼ icon appears). The
display shows LL.L or HH.H when the temperature is outside the value that can be measured.
Outdoor temperature alert function:
When the outdoor temperature becomes Higher or Lower than certain values, the weather station can be set
to emit an acoustic alert signal.
This can be set for when the temperature falls below a certain value.
When the temperature rises to above a certain value.
When the temperature is below and above a certain value.
To set the temperature alert:
Press and hold the "OUT TEMP ALERT" (39) button for at least 2 seconds.
"HI" starts flashing. Use the ▼ and ▲ buttons to select the desired high temperature alert and then press
the "OUT TEMP ALERT" (39) button.
"LO" starts flashing. Use the ▼ and ▲ buttons to select the desired low temperature alert and then press
the "OUT TEMP ALERT" (39) button to save your settings.
40