ARTHUR MARTIN AW6F3844BB Notice D'utilisation page 13

Temp.
When you select a washing programme,
the appliance automatically proposes a
default temperature.
Touch this button repeatedly until the
desired temperature value appears on the
display.
When the display shows the indicators
the appliance does not heat the water.
Essorage
When you set a programme, the appliance
automatically sets the maximum spin
speed allowed, except for programme
Denim. With this option you can change
the default spin speed.
Touch this button repeatedly to:
• Decrease the spin speed. The display
shows only the spin speeds available
for the set programme.
• Activate the No Spin option.
Set this option to deactivate all spin
phases. The appliance performs the
only draining phase of the selected
washing programme. Set this option for
very delicate fabrics. The rinse phase
uses more water for some washing
programmes. The display shows the
indicator .
• Activate the Rinse Hold option.
The final spin is not performed. The
water of the last rinse is not drained out
to prevent the fabrics from creasing.
The washing programme ends with
water in the drum.
The display shows the indicator
The door stays locked and the drum
turns regularly to reduce creasing. You
must drain the water to unlock the door.
At the end of the programme, touch the
Départ/Pause button: the appliance
performs the spinning phase and drains
the water.
The appliance empties the
water out automatically after
18 hours approximately.
• Activate the Night option.
The intermediate and the final spinning
phases are suppressed and the
programme ends with water in the
drum. This helps to reduce creasing.
The display shows the indicator
The door stays locked. The drum turns
regularly to reduce creasing. You must
drain the water to unlock the door.
As the programme is very quiet, it is
,
suitable for use at night time when
cheaper electricity tariffs are available.
In some programmes the rinses are
performed with more water.
At the end of the programme, touch the
Départ/Pause button: the appliance
performs the only draining phase.
The appliance empties the
water out automatically after
18 hours approximately.
Prélavage
With this option you can add a prewash
phase to a washing programme.
The corresponding indicator above the
touch button illuminates.
• Use this option to add a pre-wash
phase at 30 °C before the washing
phase.
This option is recommended for heavily
soiled laundry, especially if containing
sand, dust, mud and other solid
particles.
The options can increase the
programme duration.
Taches
.
Touch this button to add the stain phase
to a programme.
The corresponding indicator above the
touch button illuminates.
Use this option for laundry with hard stains
to remove.
When you set this option, put the stain
remover into compartment
13
.
.