References; Maintenance; More Information - Kenwood KDC-BT365U Mode D'emploi

TROUBLESHOOTING
Symptom Remedy
"DEVICE FULL" The number of registered devices has reached its limit.
Retry after deleting an unnecessary device. ( 19, DEVICE
DELETE)
"N/A VOICE TAG" Make sure the same voice as the registered voice tag is
used.
"NOT SUPPORT" The connected phone does not support Voice Recognition
feature or phonebook transfer.
"NO ENTRY" / "NO PAIR" There is no registered device connected/found via
Bluetooth.
"ERROR" Try the operation again. If "ERROR" appears again, check if
the device supports the function you have tried.
"NO INFO" / "NO DATA" Bluetooth device cannot get the contact information.
"HF ERROR XX" / Reset the unit and try the operation again. If this does not
"BT ERROR" solve the problem, consult your nearest service center.
26

REFERENCES

Maintenance

Cleaning the unit
Wipe off dirt on the faceplate with a dry silicone or soft cloth.
Cleaning the connector
Detach the faceplate and clean the connector gently
with a cotton swab, being careful not to damage
the connector.
Handling discs
• Do not touch the recording surface of the disc.
• Do not stick tape etc. on the disc, or use a disc with tape stuck on it.
• Do not use any accessories for the disc.
• Clean from the center of the disc and move outward.
• Clean the disc with a dry silicone or soft cloth. Do not use any solvents.
• When removing discs from this unit, pull them out horizontally.
• Remove burrs from the center hole and disc edge before inserting a disc.

More information

Visit also the following website <www.kenwood.com/cs/ce/> for:
– Latest firmware updates and latest compatible item list
– Android™ application KENWOOD MUSIC PLAY
– Any other latest information
General
• This unit can only play the following CDs:
• Detailed information and notes about the playable audio files are stated in an online manual
on the following website: www.kenwood.com/cs/ce/audiofile/
Connector (on the reverse
side of the faceplate)