BH FITNESS G855 Instructions De Montage Et Utilisation page 18

4. FITTING THE FOOT BARS.-
Then fit take the left foot (77) (marked
with the letter "L") and insert the end
bush onto the drive spindle (E) on the
main body (51) Fig.4 with washers
(112) and (113).
Insert screw (120), as shown in Fig.4,
and with the washers (118), (111) and
(112) tighten securely.Place the cap
(110).
Take the right foot bar (84), (marked
with the letter "R") and go through the
same assembly procedure as with the
left Fig.4.
Next place
embellishment covers (108), screw
them on with the screws (127) Fig.4.
5. FOOTREST ASSEMBLY.-
Pick up the left footrest (102) marked
with the letter (L), and insert the left
foot bracket in the foot strap (4) Fig.5.
Screw it with bolts (122). Next put the
rubber (3) and fit with the screws (126).
Perform the same assemble with the
right footrest (97) marked with the letter
(R) in the foot strap (6) Fig.5.
Pick up the left footrest (102) marked
with the letter (L), and insert the axle in
the foot strap (77) Fig.6.
Next, get the fottrest support plate
(115) and screw it through the center
hole with the screws (117), the spring
washer (118) and the flat washer (121),
next srew the holes at the endges of
the plate with the screws (117) the
spring washers (118) and the flat
washers (121).
Perform the same assemble with the
right footrest (97) marked with the letter
(R) in the foot strap (84) Fig.6.
ATTENTION:
retighten these screws after one
month of using the machine.
the foot
It is advisable
6. FITTING THE FOCUS BARS.-
Insert the left focus bar (85) (marked
with the letter "L") onto the focus bar
spindle Fig.7,with the bushing (114)
and the washer (113). fit the bolts
(120)at the end of the axle with spring
washer (118) and flat washers (111),
(112) with the help of the box spanners
tighten securely.
Take the right focus bar (86), (marked
with the letter "R") and go through the
same assembly procedure as with the
left.
7. FITTING THE FOOT STRAP.-
wheel
Fit the foot strap (77) and position it
with the lower focus bar (85) as shown
in Fig.8, lining up the holes.
Next, insert the bolt (117) and with
spring washer (118) with the flat
washer (121) and tighten.
Fit the foot strap (84) and position it
with the lower focus bar (102) as
shown in Fig.8, lining up the holes.
Next, insert the bolt (117) and with
spring washer (118) with the flat
washer (121) and tighten.
If you feel the foot strap has looseness,
follow these steps:
-
-
-
to
18
Remove the bolt.
Add one or more washers.
Tighten again bolt.