Important - BH FITNESS G855 Instructions De Montage Et Utilisation

1. ASSEMBLY INSTRUCTIONS.-
1. Take the unit out of its box and make
sure that all of the pieces are there:
ATTENTION: The assistance of a
second person is recommended
when assembling this machine
Fig.1 Parts list
(4) Left footrest bracket.
(6) Right footrest bracket.
(51) Main body.
(71) Front stabiliser bar with wheels.
(75) Rear stabiliser
adjustable feet.
(77) Pedal right foot.
(84) Pedal left foot.
(85) Bottom focus bar, left.
(86) Bottom focus bar, right.
(87) Main post.
(88) Handlebar stem.
(93) Left focus bar or arm.
(96) Right focus bar or arm.
(97) Left footrest.
(102) Right footrest.
(103) Monitor.
(105) Bottom post cover.
(106) Bottle holder.
(107) Handlebar embellishment cover.
(108) Embellishment cover of foot
pedal wheel.
(109) Transformer.
(115) (137) Fixing plate of pedal axle.
Fig.2 Screws and fasteners.
(110) Cap.
(111) Post washer M8.
(113) Washer D38.
(114) Post bushing.
(116) Screw M-8x25.
(117) Screw M-8x15.
(118) Spring washer M-8.
(119) Curved washer M-8.
(120) Hex. screw. M-8x15.
(121) Flat washer M-8.
(122) Screw M-8x20.
(123) Screw M-6x31.
(124) Screw M-6x12.
(125) Screw M-5x15.
(126) Auto screw M-5x15.
(127) Screw M-5x10.
Allen spanner n4, n5, n6,
Double ended ring spanner.13-17
2. FITTING THE STABILISER
BARS.-
ATTENTION: The assistance of a
second person is required for this
bar with
stage of the assembly.
Bring the front stabiliser bar with
wheels (71) to the main body (51)
positioning the wheels at the front of
the unit, Fig.3, Insert the screws (116),
and tighten securely.
Carry out the same operation to attach
the rear stabiliser bar.
Take the rear stabiliser with adjustable
feet (75), and line up the dots, Fig.3.
Insert the screws (128) with the
washers (121) and tighten with the
washer (111) and the nuts (129) and
tighten securely. Place the caps (130).
IMPORTANT: It is advisable to
retighten these screws after one
month of using the machine.
3. FITTING THE MAIN POST.-
Take the main post (87) and insert the
bottom post cover (105). Bring the
main post (87) up to boss on the main
body (51), Fig.4, connect the terminals
(5) and (1), Fig.4.
Slip the main post (87) over the boss
on the main body (51), Fig.4, making
sure not to snag any of the cables.
Refit the screws (117), the washers
(119) and the spring washers (118),
Fig.4, and tighten securely.
Lower the bottom trim section (105)
for the main post (87) down over the
boss section of the main body (51).
17