Abicor Binzel iROB Control Mode D'emploi page 50

10 Troubleshooting
Alarmcodes
E45
E50
E48
E49
E51
E52
E53
E54
E56
E60
E62
E64
E68
E70
E71
E74
E75
E76
E99
Tab. 13
EN - 22
Type Description
Alarm Compressed-air
supply
Alarm Wire burned solid
Alarm Insufficient wire
Alarm Emergency switch
Alarm Operating mode not
supported
Alarm Anti-collision
Alarm External coolant flow
sensor
E55 Alarm Max./min. current
limit breached
E57 Alarm Max./min. voltage
limit breached
E61 Alarm Max./min. speed
limit breached
E63 Warning Max./min. current
limit breached
E65 Warning Max./min. voltage
limit breached
E69 Warning Max./min. speed
limit breached
Alarm General warning
message
Alarm Coolant overheated
Alarm Wire feeder 1 current
limit exceeded
Alarm Wire feeder 2 current
limit exceeded
Alarm Coolant flow
limit exceeded
Alarm General
Explanation of the error codes
Possible solution
Connect compressed air (for air-blasting).
Remove the welding wire from the seam.
Restore safety and release the emergency stop
button.
Power source is in test mode.
Switch to MIG/MAG mode.
Move the welding torch out of the collision zone
or deactivate the sensor function in the setup if a
safety cut-out is not used.
Optional external sensor. Check that it is
working correctly. If no sensor is used,
deactivate the function in the setup.
Check for a welding error. Adjust the warning
and alarm limit in the setup if necessary.
Check for a welding error. Adjust the warning
and alarm limit in the setup if necessary.
Check for a welding error. Adjust the warning
and alarm limit in the setup if necessary.
Check for a welding error. Adjust the warning
and alarm limit in the setup if necessary.
Check for a welding error. Adjust the warning
and alarm limit in the setup if necessary.
Check for a welding error. Adjust the warning
and alarm limit in the setup if necessary.
Reset the power source. If error persists, call
Service.
Allow coolant to cool down.
Check duty cycle.
Check that the wire guide is running smoothly.
Check that the wire guide is running smoothly.
Check the cooling system. There may be a kink
in a hose or impurities in the cooling system.
Perform a reset. Check the configuration.
BAL.0333.0 • 2017-08-31
iROB Control