Loading Settings; Setting The User Level En - Abicor Binzel iROB Control Mode D'emploi

7 Operation

7.7 Loading settings

 Fig. 2 Remote control operating panel on page EN-10
A saved program can be loaded via the Program call display. Turning the
<Selector switch> (6) sets the program number, pressing it confirms the selection.
1
Fig. 8
1 <Briefly press key
2 Select a program by turning the <Selector switch> (6).
3 Confirm loading of the selected program by pressing the <Selector switch> (6).
7.8 Establishing the background parameters
Pressing and holding the <Selector switch> (6) depressed for at least 5 seconds will show the Parameter
setting display. Here the background parameters of the control are defined. A list containing parameters and
their code names can be found here:
 Tab. 14 Parameter list on page EN-24
NOTICE
• The number and type of adjustable background parameters depend on the user level.
1
2
Fig. 9
EN - 16
3
2
Program number 2
Calling saved programs
> (7).
 7.9 Setting the user level on page EN-17
6
Parameter number 3
Set value 4
Parameter setting setup display
Icon for program call 3
5 4
Save&Exit key 5
Switchover relative/absolute 6
iROB Control
1
Name of the program
1
2
3
Sending to the 7-segment display
Parameter icon
BAL.0333.0 • 2017-08-31